Adapt a 4 inch (100mm) exhaust duct to the existing backing of the Voron 2.4.
Printing Technology: FDM
Layer Height: 0.2 mm
Perimeters: 4
Infill: 40%
Infill Pattern: Gyroid
Recommended Material: ABS, ASA
Supports: No
Support Type: None
Notes:
- No supports needed
Materials Needed:
6x M3 Heat set Inserts
4x M3x8 socket head screws
2x M3x12 Socket Head Screws
Instructions:
1. Print all pieces and insert heat sets.
2. Replace stock backing with duct mount.
3. Screw Duct Adapter into ducting
4. Screw adapter to duct mount with M3x8 screws
By using the customization software, you agree to our Privacy Policy, Terms of Service, Disclaimer, EULA, and Cookie Policy.
The files provided here are for personal, non-commercial use only. Redistribution, modification, or commercial use is not allowed without prior written consent from Lunar Prototypes.